Drilled hole is treated with epoxy to hide the grain of the wood fully. Than the sealant is applied for the pickup scoop. After tying it up to the boat the ball valve is fitted with a teflon tape and hose fitting. Hose connects the pickup to the water strainer. Clamps are not shown on the picture yet. Water strainer has to have enough capacity to fit the motor cooling water needs (here 100 l/min). Connect the ports of the strainer correctly. Special elbows might be needed according to your situation and space available. Blue elbows here are made from silicone but that is not necessary. Water strainer has to be located at least 150 mm over the water line.
